A.Create a mksysb backup of the original and restore it to the new partitions
B.Use NIM to load the additional partitions from an image of the original partition
C.Create alt_disk_install clones of the original partition and assign the target disks to the new partitions
D.Use the split mirror function to split off additional copies of the original partition and assign them to the other partitions

A.The server must be installed into a location with a raised floor for optimum system cooling  and cable management.
B.The server should be purchased as a p5 590 and then upgraded to a p5 595. This will eliminate the need for a raised floor environment.
C.The server should be purchased as 32-way p5 595 and then upgraded to a 64-way. This will eliminate the need for a raised floor environment.
D.The server can be installed into a location without a raised floor if an RPQ is obtained. It is a strong IBM recommendation for a raised floor, not a requirement.

A.Enable DHCP server on the HMC
B.Configure host name and IP address on DNS server
C.Manually set the IP address of the service processor
D.Connect a RS-232 cable from the HMC to the service processor

A.Resources cannot be shared with an i5 partition when it is put on a pSeries. The i5 partition needs its own 9411-100 tower because of IOP. V5R3 OS or later is required. There is a maximum of two partitions in a 590.
B.Resources cannot be shared between partitions when i5/OS is put on a pSeries. The i5 partition needs its own 9411-100 tower because of IOP. i5/OS can be at V5R2 or a V5R3. Currently only one i5 partition is allowed. 
C.V5R3 is required for the i5 partitions. Virtual IO Server is not supported for the i5/OS partitions to share storage. Up to 10 i5 partitions per processor are allowed (a maximum of two processors for up to 20 partitions). 
D.Processor and memory resources can be shared between AIX 5L, Linux and i5/os partitions. i5/OS needs to be at V5R3, and Virtual IO Server is not supported for the i5/OS partition to share storage. On a 1.65 GHz POWER5 p5 590 there is a maximum of one partition.

A.An administrative VLAN with port 1808
B.Port 657 which must remain open to TCP/IP and UDP traffic
C.Network addresses are provided by DHCP services on the network
D.DHCP on the HMC is required to be on to communicate between LPAR and HMC

A.backup command
B.Tivoli Storage Manager
C.Tivoli Disaster Recovery Manager
D.Store mksysb images on a NIM server

A.DLPAR functions are not available for cloned partitions
B.The new partition has the same node number as the original LPAR
C.Additional filesets need to be reinstalled after the alt_disk_install cloning
D.The speed and duplex settings on the Ethernet adapter on the new LPAR is misconfigured

A.Quorum was not turned off
B.Paging space was not mirrored
C.The dump space was not mirrored
D.The surviving disk was too small

A.Add additional logical volumes two at a time
B.Add additional physical volumes two at a time
C.Create a columned striped logical volume using -C option of mklv
D.Create an extendable striped logical volume using -E option of mklv

A.Backup critical console data
B.Backup a bootable image to tape
C.Create mksysb image and store on a NIM server
D.Create mksysb image and store on an NFS server

A.APV, AIX5.2ML4
B.AIX5.3 or i5/OS
C.APV, i5/OS, AIX5.3
D.APV, AIX5.3 or SuSE9