A. Neighbor Table
B. SRF Table
C. RTP Table
D. Topology Table
E. Query Table
F. Dual Table

A. The exchange of an advertisement is triggered by a change in the network.
B. All routers exchange routing tables with each other in a multipoint network.
C. Packets are routed based upon the shortest path to the destination.
D. Paths are chosen depending on the cost efficiency factor.
E. Every router in an OSPF area is capable of representing the entire network topology.
F. Only the designated router in an OSPF area can represent the entire network topology.

A. IGRP
B. ICMP
C. OSPF
D. RIP v1
E. RIP v2
F. EIGRP

A. Spanning Tree Protocol
B. Shortest path first tree
C. Link-state advertisements (LSA)
D. Hold-down timers
E. Split horizon
F. VRP

A.RIPv1
B.RIPv2
C.EIGRP
D.IGRP
E.OSPF
F.VLSM

A. RIP
B. IPX RIP
C. IGRP
D. OSPF
E. IS-IS

A. A routing protocol is assigned to an interface and determines the method of packet delivery.
B. A routed protocol is assigned to an interface and determines the method of packet delivery.
C. A routing protocol determines the path of a packet through a network.
D. A routed protocol determines the path of a packet through a network.
E. A routing protocol operates at the transport layer of the OSI model.
F. A routed protocol updates the routing table of a router.

A. source MAC address
B. source IP address
C. source switch port
D. destination IP address
E. destination port address
F. destination MAC address

A. The frame is dropped.
B. The frame is addressed with a broadcast MAC address and sent out all ports.
C. The frame is sent out all ports except the receiving port.
D. An ARP request is sent out all ports except the receiving port.
E. A destination unreachable message is sent back to the source address.
F. None of the above.

A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.

A. Hosts use a logical ring topology.
B. Hosts use a logical bus topology
C. Hosts must wait for an electronic signal to transfer data.
D. Hosts are directly connected to a wiring concentrator called a MSAU.