A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.

A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.

A. EIA/TIA
B. Q.932
C. Q.933A
D. IEEE
E. Cisco
F. Annex D

A.serialup
B.clock
C.clockrate
D.dcerate
E.dterate

A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.

A. Q.931
B. IPCP
C. multilink
D. CHAP
E. callback

A.SSL
B.SLIP
C.PAP
D.LAPB
E.CHAP
F.VNP

A. TestKRouter(config-if)# Encapsulation frame-relay dot1q
B. TestKRouter(config-if)# Encapsulation frame-relay aal5snap
C. TestKRouter(config-if)# Encapsulation frame-relay ietf
D. TestKRouter(config-if)# Encapsulation frame-relay isl
E. None of the above

A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
E. frame-relay pvc

A. The local DLCI on each subinterface of the Frame Relay.
B. The Frame Relay encapsulation on the physical interface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point

A. Router# ping 192.168.13.26
B. Router# debug access-list 172
C. Router# show open ports 192.168.13.26
D. Router# show access-list
E. Router# show ip interface