A. Blocking
B. Auto
C. Desirable
D. On
E. Transparent
F. Learning

A. The TESTKING VLAN must be created.
B. The desired ports must be added to the new TESTKING VLAN.
C. The TESTKING VLAN must be added to all of the domains.
D. The TESTKING VLAN must be named.
E. An IP address must be configured for the TESTKING VLAN.
F. None of the above. VLAN creations are automatic.

A. VTP
B. ISL
C. CDP
D. 802.1Q
E. 802.1p
F. LLC
G. IETF

A.STP
B.VTP
C.EIGRP
D.SNMP
E.CDP
F.None of the above

A. VLANs logically divide a switch into multiple, independent switches at Layer 2.
B. Trunk links can carry traffic for multiple VLANs.
C. VLAN implementation significantly increases traffic due to added trunking information.
D. A VLAN can span multiple switches.
E. VLANs typically increase the number of switches needed
F. VLANs typically decrease the number of switches needed

A. The VLAN must be created
B. The VLAN must be named
C. An IP address and subnet mask must be configured for the new VLAN
D. The desired ports must be added to the new VLAN
E. The VLAN must be added to the existing VTP Domain

A. They are used to find the best path through a network.
B. They allow the exchange of filtering tables.
C. They specify different implementations of the Spanning-Tree Protocol.
D. They allow the exchange of routing tables
E. They provide inter-switch VLAN communication.

A. They increase the size of collision domains
B. They allow logical grouping of users by function.
C. They can enhance network security.
D. They increase the size of the broadcast domain while decreasing the number of collision domains.
E. They increase the number of broadcast domains while decreasing the size of the broadcast domains.
F. They simplify switch administration.

A. All defined VLANs are allowed on the trunk by default.
B. Each VLAN, or VLAN range, that is specified with the switchport mode command.
C. Each VLAN, or VLAN range, that is specified with the vtp domain command.
D. Each VLAN, or VLAN range, that is specified with the vlan database command.

A. You must set each end of the trunk line to IEEE 802.1e encapsulation.
B. You must set the same VTP management domain name on both switches.
C. You must set all ports on the two switches as access ports.
D. You must configure one of the switches as a VTP server.
E. You must use a rollover cable to connect the two switches.

A. Switch(config)# switchport trunk encapsulation isl
B. Switch(config)# switchport trunk encapsulation ietf
C. Switch(config-if)# switchport trunk encapsulation isl
D. Switch(config-if)# switchport trunk encapsulation ietf
E. Switch(config-if)# switchport trunk encapsulation dot1q