A. The summarized address for all internal subnetted addresses.
B. A private IP address assigned to a host on the inside network.
C. A registered address that represents an inside host to an outside network.
D. A unique IP address used on an internal network
E. Non of the above

A. IP address: 192.168.20.14 Subnet Mask: 255.255.255.248 Default Gateway:192.168.20.9
B. IP address: 192.168.20.254 Subnet Mask: 255.255.255.0 Default Gateway:192.168.20.1
C. IP address: 192.168.20.30 Subnet Mask 255.255.255.248 Default Gateway:192.168.20.25
D. IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:192.168.20.17
E. IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:192.168.20.25

A. The command is used to establish a static route.
B. The default administrative distance is used.
C. The command is used to configure the default route.
D. The subnet mask for the source address is 255.255.255.0
E. The command is used to establish a stub network

A. TestKingRouter(config)# router ospf 0
B. TestKingRouter(config)# router ospf 1
C. TestKingRouter(config)# router ospf area 0
D. TestKingRouter(config)# network 192.168.16.0 0.0.0.255 0
E. TestKingRouter(config)# network 192.168.16.0 0.0.0.255 area 0
F. TestKingRouter(config)# network 192.168.16.0 255.255.255.0 area 0

A. Point-to-point
B. Point to multipoint
C. Broadcast
D. Non-broadcast multi-access

A. All OSPF networks require the use of multiple areas
B. Multiple OSPF areas must connect to area 0
C. Single area OSPF networks must be configured in area 1
D. Areas can be assigned any number from 0 to 63535
E. Area 0 is called the backbone area
F. Each OSPF area need to be configured with a loopback interface

A. It confines network instability to a single area of network.
B. It increases the routing overhead of the network
C. It supports VLSM
D. It routes between Autonomous Systems.
E. It allows extensive control of routing updates

A. 1
B. 64
C. 1562
D. 64000
E. 1500

A. The exchange of advertisement is triggered by a change in the network.
B. All routers exchange routing tables with each other iIn a multipoint network.
C. Packets are routed based upon the shortest path to the destination.
D. Paths are chosen depending on the cost efficiency factor.
E. Every router in an OSPF area is capable of representing the entire network topology.
F. Only the designated router in an OSPF area can represent the entire network topology.

A. Distance vector protocols send the entire routing table to directly connected neighbors.
B. Distance vector protocols are responsible for sending updates to all networks listed in the routing table.
C. Link state protocols are responsible for sending the entire routing table to the whole network.
D. Link state protocols send updates regarding their own links status to all other routers on the network.

A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.