A. The number of FECN packets that are received by the router
B. The number of BECN packets that are received by the router
C. The ip address of the local router
D. The value of the local DLCI
E. The status of the PVC that is configured on the router

A. configure static frame relay map entries for each subinterface network.
B. remove the ip address from the physical interface
C. create the virtual interfaces with the interface command
D. configure each subinterface with its own IP address
E. disable split horizon to prevent routing loops between the subinterface networks
F. encapsulate the physical interface with multipoint PPP

A.show inventory
B.show flash：filesys
C.dirflash：include chassis
D.show diag
E.show controllers

A. RIP is an example of distance vector routing protocols.
B. Updates are periodic and include the entire routing table.
C. Routing updates are sent only after topology changes
D. The protocol can be useful in hub-and-spoke and hierarchical networks.
E. Convergence is usually faster than with link state protocols
F. Each router has its own view of the topology

A.172.22.243.127
B.172.22.243.191
C.172.22.243.190
D.10.16.33.98
E.10.17.64.34
F.192.168.1.160

A. The network administrator can apply port security to dynamic access ports
B. The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
C. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
D. The network administrator can apply port security to EtherChannels.
E. When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.

A. they offer simpler management in large internetworks.
B. you can control logging messages.
C. they allow packets to be filtered based on upper-layer session information.
D. you can set a time-based security policy.
E. they provide a level of security against spoofing.
F. they are used to authenticate individual users.

A. it is a layer 2 messaging protocol which maintains vlan configurations across network.
B. it includes an 8-bit field which specifies the priority of a frame.
C. it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D. it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E. it is a trunking protocol capable of carring untagged frames.

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC

A. Microsegmentation decreases the number of collisions on the network.
B. if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C. Spanning Tree Protocol allows switches to automatically share vlan information.
D. In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E. Establishing vlans increases the number of broadcast domains.
F. Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.

A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan