A.The network administrator can apply port security to dynamic access ports
B.The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
C.The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
D.The network administrator can apply port security to EtherChannels.
E.When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.

A.Security increases because only the network administrator may change the routing tables
B.Configuration complexity decreases as network size increases
C.Routing updates are automatically sent to neighbors
D.Route summarization is compued automatically by the router
E.Routing traffic load is reduced when used in stub network links
F.An efficient algorithm is used to build routing tables,using automatic updates
G.Routing tables adapt automatically to topology changes.

A.multicast
B.broadcast
C.allcast
D.podcast
E.anycast

A.A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
B.A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
C.A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
D.A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.

A.10.0.0.0/21
B.10.0.0.0/22
C.10.0.0.0/23
D.10.0.0.0/24

A.255.255.255.0
B.255.255.254.0
C.255.255.252.0
D.255.255.248.0

A. NIC
B. BIA
C. OUI
D. VAI

A.global unicast
B.anycast
C.multicast
D.unspecified address

A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.

A.There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.
B.A single interface may be assigned multiple IPv6 addresses of any type.
C.Every IPv6 interface contains at least one loopback address.
D.The first 64 bits represent the dynamically created interface ID.
E.Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.

A.The loopback addresses are on different subnets
B.The value of the dead timers on the router are different
C.Route summarization is enabled on both routers
D.The process indentifier on router A is different than the process identifier on router B