A.access-list 50 deny 192.168.1.1 0.0.0.255
B.access-list 110 permit ip any any
C.access-list 2500 deny tcp any host 192.168.1.1 eq 22
D.access-list 101 deny tcp any host 192.168.1.1

A.you can apply multiple access lists with the same protocol or in different direction.
B.you can config one access list,per direction,per layer 3 protocol
C.you can place as many access lists as you want on any interface
D.you can apply only one access list on any interface

A.They are always present in the NAT table.
B.They allow connection to be initiated from the outside.
C.They can be configured with access lists, to allow two or more connections to be initiated from the outside.
D.They require no inside or outside interface markings because addresses are statically defined.

A.network or subnetwork IP address
B.broadcast address on the network
C.IP address leased to the LAN
D.IP address used by the interfaces
E.manually assigned address to the clients
F.designated IP address to the DHCP server

A.Set the IP gateway to be used by the network.
B.Perform host discovery used DHCPDISCOVER message.
C.Configure IP address parameters from DHCP server to a host.
D.Provide an easy management of layer 3 devices.
E.Monitor IP performance using the DHCP server.
F.Assign and renew IP address from the default pool.

A.The address is removed from the pool until the conflict is resolved.
B.The address remains in the pool until the conflict is resolved.
C.Only the IP detected by Gratuitous ARP is removed from the pool.
D.Only the IP detected by Ping is removed from the pool.
E.The IP will be shown, even after the conflict is resolved.

A.Addresses are permanently assigned so that the host uses the same address at all times.
B.Addresses are assigned for a fixed period of time. At the end of the period, a new request for an address must be made, and another address is then assigned.
C.Addresses are leased to hosts. A host will usually keep the same address by periodically contacting the DHCP server to renew the lease.
D.Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.

A.reflexive
B.extended
C.standard
D.dynamic

A.destination address and wildcard mask
B.source address and wildcard mask
C.destination address and subnet mask
D.source address and subnet mask

A.NAT protects network security because private networks are not advertised.
B.NAT accelerates the routing process because no modifications are made on the packets.
C.Dynamic NAT facilitates connections from the outside of the network.
D.NAT facilitates end-to-end communication when IPsec is enable.
E.NAT eliminates the need to re-address all host that require extemal access.
F.NAT conserves addresses through host MAC-level multiplexing.

A.Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.
B.Addresses are permanently assigned so that the hosts uses the same address at all times.
C.Addresses are assigned for a fixed period of time, at the end of the period, a new request for an address must be made.
D.Addresses are leased to hosts, which periodically contact the DHCP server to renew the lease.