多项选择题X 纠错
A.It allows the standby RP to take control of the device after a hardware or software fault on the active RP.
B.It is a Layer 3 function that works with SSO to minimize the amount of time a network is unavailable tousers following a switchover.
C.It is supported by the implementation of EIGRP, OSPF, RIPv2, and BGP protocols.
D.It synchronizes startup configuration, startup variables, and running configuration.
E.The main objective of NSF is to continue forwarding IP packets following a switchover.
F.Layer 2 802.1w or 802.1s must be used, as 802.1d cannot process the Layer 2 changes.
G.Routing protocol tuning parameters must be the same as the NSF parameters, or failover will beinconsistent.
你可能喜欢
单项选择题
A. The VSS switch must be the root bridge for all VLANs and is automatically designated
B. The VSS switch is defined in RFC 4318 as a managed object
C. The PAgP+ or LACP protocols are used to maintain the operational state of the VSS devices
D. A VSS interoperates with a virtual port channel
E. The 802.1Q or ISL protocols are used to maintain the operational state of the VSS devices
F. A VSS increases the size of the spanning-tree domain
单项选择题
A.telnet 11.1.1.4 /vrf-source red
B.telnet 11.1.1.4 source /vrf red
C.telnet 11.1.1.4 /source vrf red
D.telnet 11.1.1.4 /vrf red
E.telnet 11.1.1.4 vrf red
单项选择题
A.all routes in the routing table
B.only the IGP and BGP routes in the routing table
C.only the BGP routes in the routing table
D.only the IGP routes in the routing table
单项选择题
A.ip vrf CCIE
B.ipv6 vrf CCIE
C.vrf definition CCIE
D.ipv6 vrf definition CCIE
多项选择题
A. Fa7/28
B. Fa7/20
C. Gi3/7
D. Fa4/2
E. Fa4/14
F. Fa4/38
G. Fa6/28
H. Fa5/7
单项选择题
A.0
B.1
C.255
D.256
多项选择题
A.6to4
B.6over4
C.ISATAP
D.6PE
E.GRE
单项选择题
A. Both support normal and extended VLAN ranges.
B. ISL is a Cisco proprietary encapsulation method and 802.1Q is an IEEE standard.
C. ISL encapsulates the original frame.
D. Both support native VLANs.
E. 802.1Q does not encapsulate the original frame.
单项选择题
A.EIGRPv6 will form a neighbor relationship.
B.EIGRPv6 will not form a neighbor relationship.
C.EIGRPv6 will form a neighbor relationship, but with the log MSG: "EIGRPv6 neighbor not on a commonsub net."
D.EIGRPv6 will form a neighbor relationship, but routes learned from that neighbor will not be installed inthe routing table.
多项选择题
A. It supports autonegotiation for both ISL and IEEE 802.1Q trunks.
B. It must be disabled on an interface if you do not want the interface to work as a trunk or start negotiation to become a trunk.
C. It is a point-to-multipoint protocol.
D. It is a point-to-point protocol.
E. It is not supported on private VLAN ports or tunneling ports.