A.Global addresses start with 2000::/3.
B.Link-local addresses start with FE00:/12.
C.Link-local addresses start with FF00::/10.
D.There is only one loopback address and it is ::1.
E.If a global address is assigned to an interface, then that is the only allowable address for the interface.

A.The subnet mask in use is 255.255.255.192.
B.The subnet mask in use is 255.255.255.128.
C.The IP address 172.16.1.25 can be assigned to hosts in VLAN1
D.The IP address 172.16.1.205 can be assigned to hosts in VLAN1
E.The LAN interface of the router is configured with one IP address.
F.The LAN interface of the router is configured with multiple IP addresses.

A.B514：82C3：0029：：EC7A：0000：EC72
B.B514：82C3：0029：EC7A：EC72
C.B514：82C3：：0029：EC7A：0：EC72
D.B514：82C3：：0029：EC7A：EC72

A.reduces routing table entries
B.auto-negotiation of media rates
C.efficient utilization of MAC addresses
D.dedicated communications between devices
E.ease of management and troubleshooting

A.VLANs establish broadcast domains in switched networks.
B.VLANs utilize packet filtering to enhance network security.
C.VLANs provide a method of conserving IP addresses in large networks.
D.VLANs provide a low-latency internetworking alternative to routed networks.
E.VLANs allow access to network services based on department, not physical location.
F.VLANs can greatly simplify adding, moving, or changing hosts on the network.

A.the switch with the lowest MAC address
B.the switch with the higest MAC address
C.the switch witch the higest IP address
D.the switch with the lowest IP address

A.AhubisconnecteddirectlytoFastEthernet0/5
B.FastEthernet0/1isconfiguredasatrunklink.
C.FastEthernet0/5hasstaticallyassignedmacaddress
D.InterfaceFastEthernet0/2hasbeendisable.
E.MultipledevicesareconnecteddirectlytoFastEthernet0/1.
F.FastEthernet0/1isconnectedtoahostwithmultiplenetworkinterfacecards.

A.RSTP cannot operate with PVST+.
B.RSTP defines new port roles.
C.RSTP defines no new port states.
D.RSTP is a proprietary implementation of IEEE 802.1D STP.
E.RSTP is compatible with the original IEEE 802.1D STP.

A.transparent
B.auto
C.on
D.desirable
E.client
F.forwarding

A.redundant
B.spanned
C.provisioned
D.converged

A.Switch3, port fa0/1
B.Switch3, port fa0/12
C.Switch4, port fa0/11
D.Switch4, port fa0/2
E.Switch3, port Gi0/1
F.Switch3, port Gi0/2