A.RSTP cannot operate with PVST+.
B.RSTP defines new port roles.
C.RSTP defines no new port states.
D.RSTP is a proprietary implementation of IEEE 802.1D STP.
E.RSTP is compatible with the original IEEE 802.1D STP.

A.transparent
B.auto
C.on
D.desirable
E.client
F.forwarding

A.redundant
B.spanned
C.provisioned
D.converged

A.Switch3, port fa0/1
B.Switch3, port fa0/12
C.Switch4, port fa0/11
D.Switch4, port fa0/2
E.Switch3, port Gi0/1
F.Switch3, port Gi0/2

A.All ports will be in a state of discarding, learning, or forwarding.
B.Thirty VLANs have been configured on this switch.
C.The bridge priority is lower than the default value for spanning tree.
D.All interfaces that are shown are on shared media.
E.All designated ports are in a forwarding state.
F.The switch must be the root bridge for all VLANs on this switch.

A.802.1Q native VLAN frames are untagged by default.
B.802.1Q trunking ports can also be secure ports.
C.802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.802.1Q trunks require full-duplex, point-to-point connectivity.
E.802.1Q trunks should have native VLANs that are the same at both ends.

A.one
B.six
C.twelve
D.two

A.transparent
B.auto
C.on
D.desirable

A.PVST+reduces the CPU cycles for all the switches in the network
B.PVST+automatically selects the root bridge location,to provide optimized bandwidth usage.
C.PVST+allow the root switch location to be optimized per vlan.
D.PVST+supports Layer 3 load balancing without loops.

A.Switch1
B.Switch2
C.Switch3
D.Switch4

A.Host B and the switch need to be in the same subnet.
B.The switch needs and appropriate default gateway assigned.
C.The switch interface connected to the router is down.
D.Host B need to be assigned an IP address in vlan 1.
E.The switch interfaces need the appropriate IP addresses assigned.