A.toxic
B.flammable
C.explosive
D.all of the above

A.Fire pump and lube oil pump
B.Lube oil pump and distilling plant
C.Distilling plant and shaft alley door
D.Shaft alley door and fixed CO2 release

A.bypass the high pressure stage to the low pressure stage on 100% of the air compressors in service
B.prevent excessive inter-stage pressure buildup
C.control compressor discharge pressure
D.remove all but the frictional load during starting

A.The relief valves in the system should be readjusted
B.The filters and strainers should be checked frequently
C.All system pressure should be readjusted
D.The system should be drained and renewed with a fluid of different operating characteristics

A.100℃
B.125℃
C.150℃
D.175℃

A.maintain radial alignment between the pump impeller and casing
B.absorb all impeller shaft end thrust
C.prevent water leakage to the atmosphere
D.prevent wear of the pump casing and/or impeller

A.psychrometer
B.salinometer
C.anemometer
D.sphygmomanometer

A.A large change of viscosity occurs with a minor change in temperature
B.No change in viscosity occurs with any change in temperature
C.Very little change in viscosity occurs with a significant change in temperature
D.The viscosity of the oil increases with an increase in temperature

A.pump would be very noisy
B.pump would vibrate excessively
C.pump would develop insufficient flow
D.stuffing box would leak excessively

A.gravity and feed oil cups
B.grease cups
C.hand during installation
D.leakage through the stuffing box

A.a needle gun
B.soap and water
C.a wire brush
D.a chipping hammer