A.PAT B.NAT C.Multicast D.Subnetting
A. the cause of routing errors. B. the number of switches on the network. C. the number of users on the network. D. where network latency will occur.
A.their legal department B.IANA C.IEEE D.their IT department
A. OSPF B. RIP C. EIGRP D. IGRP E. RIPv2
A.802.11a B.802.11g C.802.11b D.802.11n
A. Setup an ACL that allows and logs all IP traffic between the two computers B. Configure a spanning tree to check for a loop C. Setup a span port on the switch to watch for CRC errors D. Connect both computers using a crossover cable
A. Mesh B. Point to point C. Point to multipoint D. Ring
A. Physical network diagram B. Job log C. Acceptable use policy D. Baseline documentation E. Wiring schematic
A.IGP B. EIGRP C. EGP D. BGP
A. Enable file and print share B. FTP C. VPN D. Map a drive
